Tapster 3+
Tapster 3+
The NEW Tapster 3 robots tap and swipe the touchscreen of a mobile device just like a human finger does. The delta design provides a quick-moving robot for all of your functional testing needs. This configuration is equipped with a mounted USB camera and may also be customized with a number of modules. The Push Button Module (pictured) can press the physical side buttons on a device. Tapster 3+ uses larger components to interact with a larger touch area. Tapster 3+ can accommodate most tablets in addition to phones and smaller-sized devices.

Challenge:
Customer needed to turn on the tablet, connect to wifi, download an app, and capture screen shots of the successful process.
Solution:
Tapster 3+ with the Push Button Module and a mounted Camera enabled every step in the customer process.
- Delta design
- Rubber-tipped capacitive touchscreen end effector
- Sliding mounts and grips enable multiple configurations to press top, side, or back buttons of the customer’s device.
- Mounted USB camera to capture screen shots
- Ships assembled, tested, and ready to go with minimal set-up
Specs:
- Tappable Area: 148mm x 236mm x 20mm
- Software: Grbl firmware; programmed by G-code
- Motion System: Dynamixel XL series
- USB camera: 2MP full HD 1080; M12 2.8-12mm varifocal lens
- Power: 12V power supply included
Requirements:
- Computer running Mac, Windows, or Linux
- USB port
Tapster 3+ Common Customizations:
- Custom jig to hold non-phone devices
- Add PBM (Push Button Module) to push physical buttons
- Vertical mount orientation
- Chip Dip module for payment use cases
Photo is Tapster 3+ customized with PBM.